I. J. of Electrical & Electronics Research
Research Article | 
PMSG Wind Turbine Based Current Fed Three Phase Inverter with Model Predictive Control
Author(s) : Vijayaprabhu. A1 and Kumaresan. M2
Published In : International Journal of Electrical and Electronics Research (IJEER) Volume 10, Issue 2
Publisher : FOREX Publication
Published : 28 June 2022
e-ISSN : 2347-470X
Page(s) : 282-289
Abstract
Design of an improved Permanent Magnet Synchronous Generator (PMSG) wind turbine power based Current Fed Inverter (CFI) using Model Predictive Controller (MPC) is proposed in this paper. Optimum torque control is proposed in wind energy conversion system, MPC is used to adjust the dynamic response time based on the application need. This model deals with torque control strategy of PMSG in the machine side controller. Impact of normal mode of operation by the copper losses and torque ripples are minimized by maximizing the average torque. Synthetization of adequate stator phase current are obtained naturally. Uncertainty of the steady state errors of the plant and parameter error are rectified in the system model. The designed CFI with MPC was implemented using medium range wind turbine in MATLAB /Simulink. The simulation output shows the better efficiency in over modulation region by the proposed CFI with controller. Constant switching frequency is maintained and efficient required dynamic response (DR) value is attained.
Keywords: PMSG, Wind Turbine, Current Fed Inverter, Model predictive control, Over modulation, Dynamic response time
Vijayaprabhu. A, Research Scholar, Department of Electrical and Electronics Engineering, Dr. M.G.R. Educational and Research institute, Chennai. India; Email: vijayaprabhu85@gmail.com
Kumaresan. M, Professor, Department of Electronics and Communication Engineering, Dr. M.G.R. Educational and Research institute, Chennai. India; Email: dr.kumaresan09@gmail.com
[1] A. Jain, S. Shankar, and V. Vanitha, “Power generation using Permanent Magnet Synchronous Generator (PMSG) based variable speed wind energy conversion system (WECS): An overview,” J. Green Eng., vol. 7, no. 4, 2018, doi: 10.13052/jge1904-4720.742.[Cross Ref]
[2] Sandhya Kulkarni, Dr. Archana Thosar (2021), Performance Analysis of Permanent Magnet Synchronous Machine due to Winding Failurese. IJEER 9(3), 76-83. DOI: 10.37391/IJEER.0903081.[Cross Ref]
[3] M. Abdelrahem, C. M. Hackl, and R. Kennel, “Finite Position Set-Phase Locked Loop for Sensorless Control of Direct-Driven Permanent-Magnet Synchronous Generators,” IEEE Trans. Power Electron., vol. 33, no. 4, 2018, doi: 10.1109/TPEL.2017.2705245.[Cross Ref]
[4] Vikash Kumar, Amit Choudhary (2021), Solar Water Pumping Model Using Zeta Converter for Irrigation Application. IJEER 9(3), 84-88. DOI: 10.37391/IJEER.090309.[Cross Ref]
[5] J. Deng, J. Wang, S. Li, H. Zhang, S. Peng, and T. Wang, “Adaptive damping design of PMSG integrated power system with virtual synchronous generator control,” Energies, vol. 13, no. 8, 2020, doi: 10.3390/en13082037.[Cross Ref]
[6] M. Abdelrahem, H. Eldeeb, C. Hackl, R. Kennel, and J. Rodriguez, “Computationally efficient predictive direct torque control strategy for pmsgs without weighting factors,” in PCIM Europe Conference Proceedings, 2018, no. 225809.[Cross Ref]
[7] I. Maaoui-Ben Hassine, M. W. Naouar, and N. Mrabet-Bellaaj, “Predictive control strategies for wind turbine system based on permanent magnet synchronous generator,” ISA Trans., vol. 62, 2016, doi: 10.1016/j.isatra.2015.12.002.[Cross Ref]
[8] L. Bigarelli, M. Di Benedetto, A. Lidozzi, L. Solero, S. A. Odhano, and P. Zanchetta, “PWM-Based Optimal Model Predictive Control for Variable Speed Generating Units,” IEEE Trans. Ind. Appl., vol. 56, no. 1, 2020, doi: 10.1109/TIA.2019.2955662.[Cross Ref]
[9] J. S. Lee, Y. Bak, K. B. Lee, and F. Blaabjerg, “MPC-SVM method for Vienna rectifier with PMSG used in Wind Turbine Systems,” in Conference Proceedings - IEEE Applied Power Electronics Conference and Exposition - APEC, 2016, vol. 2016-May, doi: 10.1109/APEC. 2016.7468358.[Cross Ref]
[10] I. Jlassi and A. J. Marques Cardoso, “Enhanced and Computationally Efficient Model Predictive Flux and Power Control of PMSG Drives for Wind Turbine Applications,” IEEE Trans. Ind. Electron., vol. 68, no. 8, 2021, doi: 10.1109/TIE.2020.3005095.[Cross Ref]
[11] Z. X. Xing, H. Y. Wang, H. X. Wang, and Y. L. Li, “Rotor position estimation method of permanent magnet wind generator based on finite position set-phase locked loop,” Dianji yu Kongzhi Xuebao/Electric Mach. Control, vol. 23, no. 11, 2019, doi: 10.15938/j.emc.2019.11.002.[Cross Ref]
[12] M. Abdelrahem, C. M. Hackl, R. Kennel, and J. Rodríguez, “Efficient Direct-Model Predictive Control With Discrete-Time Integral Action for PMSGs,” IEEE Trans. Energy Convers., vol. 34, no. 2, 2019, doi: 10.1109/TEC.2018.2872626.[Cross Ref]
[13] Femy P. H., Jayakumar J. (2021), A Review on the Feasibility of Deployment of Renewable Energy Sources for Electric Vehicles under Smart Grid Environment. IJEER 9(3), 57-65. DOI: 10.37391/IJEER.0903061.[Cross Ref]
[14] C. Qin, C. Zhang, X. Xing, X. Li, A. Chen, and G. Zhang, “Simultaneous Common-Mode Voltage Reduction and Neutral-Point Voltage Balance Scheme for the Quasi-Z-Source Three-Level T-Type Inverter,” IEEE Trans. Ind. Electron., vol. 67, no. 3, 2020, doi: 10.1109/TIE.2019.2907501.[Cross Ref]
[15] M. Liu et al., “Dual Cost Function Model Predictive Direct Speed Control with Duty Ratio Optimization for PMSM Drives,” IEEE Access, vol. 8, 2020, doi: 10.1109/ACCESS.2020.3007627.[Cross Ref]
[16] M. X. Bui, D. Guan, D. Xiao, and M. F. Rahman, “A Modified Sensorless Control Scheme for Interior Permanent Magnet Synchronous Motor over Zero to Rated Speed Range Using Current Derivative Measurements,” IEEE Trans. Ind. Electron., vol. 66, no. 1, 2019, doi: 10.1109/TIE.2018.2823663.[Cross Ref]
[17] M. Yoshida and S. Masuda, “A gain scheduled PID control method based on nonlinear model predictive control,” in IFAC Proceedings Volumes (IFAC-PapersOnline), 2004, vol. 37, no. 12, doi: 10.1016/ S1474-6670(17)31514-8.[Cross Ref]
[18] Y. Errami, A. Obbadi, and S. Sahnoun, “A survey of control strategies for grid connected wind energy conversion system based permanent magnet synchronous generator and fed by multi-level converters,” Int. J. Model. Identif. Control, vol. 35, no. 1, 2020, doi: 10.1504/IJMIC.2020.113288.[Cross Ref]
[19] Y. Errami, A. Obbadi, S. Sahnoun, M. Barara, M. Ouassaid, and M. Maaroufi, “Control of High-Power Wind Energy Conversion System Fed by Multi-level Converters,” in Energy Procedia, 2017, vol. 119, doi: 10.1016/j.egypro.2017.07.071.[Cross Ref]
[20] L. D. Zhou, X. Li, G. Yao, and B. S. Mei, “Modeling and control for six phase permanent magnet wind turbine driven by MP-MMC,” Dianji yu Kongzhi Xuebao/Electric Mach. Control, vol. 23, no. 5, 2019, doi: 10.15938/j.emc.2019.05.011.[Cross Ref]
[21] N. M. A. Freire and A. J. M. Cardoso, “A fault-tolerant PMSG drive for wind turbine applications with minimal increase of the hardware requirements,” IEEE Trans. Ind. Appl., vol. 50, no. 3, 2014, doi: 10.1109/TIA.2013.2282935.[Cross Ref]
[22] L. Guo, X. Zhang, S. Yang, Z. Xie, and R. Cao, “A Model Predictive Control-Based Common-Mode Voltage Suppression Strategy for Voltage-Source Inverter,” IEEE Trans. Ind. Electron., vol. 63, no. 10, 2016, doi: 10.1109/TIE.2016.2574980.[Cross Ref]
[23] H. Ye, B. Yue, X. Li, and K. Strunz, “Modeling and simulation of multi-scale transients for PMSG-based wind power systems,” Wind Energy, vol. 20, no. 8, 2017, doi: 10.1002/we.2097.[Cross Ref]
[24] M. Li and Y. Wang, “Research on frequency fuzzy adaptive additional inertial control strategy for D-PMSG wind turbine,” Sustain., vol. 11, no. 15, 2019, doi: 10.3390/su11154241.[Cross Ref]
[25] E. G. Shehata and J. Thomas, “Simple Model Predictive Control of High Power Direct-Driven PMSG Wind Energy Systems,” in Proceedings of the IEEE International Conference on Industrial Technology, 2021, vol. 2021-March, doi: 10.1109/ICIT46573.2021.9453506.[Cross Ref]
[26] A. A. Ghany et al., “Novel switching frequency fcs‐mpc of pmsg for grid‐connected wind energy conversion system with coordinated low voltage ride through,” Electron., vol. 10, no. 4, 2021, doi: 10.3390/electronics10040492.[Cross Ref]
[27] L. Guo, X. Zhang, S. Yang, Z. Xie, L. Wang, and R. Cao, “Simplified model predictive direct torque control method without weighting factors for permanent magnet synchronous generator-based wind power system,” IET Electr. Power Appl., vol. 11, no. 5, 2017, doi: 10.1049/iet-epa.2015.0620.[Cross Ref]
[28] Y. C. Lin, V. E. Balas, J. F. Yang, and Y. H. Chang, “Adaptive takagi-sugeno fuzzy model predictive control for permanent magnet synchronous generator-based hydrokinetic turbine systems,” Energies, vol. 13, no. 20, 2020, doi: 10.3390/en13205296.[Cross Ref]
[29] N. Mohan, Advanced Electric Drives: Analysis, Control, and Modeling Using MATLAB/Simulink, vol. 9781118485484. 2014.[Cross Ref]
[30] K. Sindhya, A. Manninen, K. Miettinen, and J. Pippuri, “Design of a Permanent Magnet Synchronous Generator Using Interactive Multiobjective Optimization,” IEEE Trans. Ind. Electron., vol. 64, no. 12, 2017, doi: 10.1109/TIE.2017.2708038.[Cross Ref]
[31] W. Gul, Q. Gao, and W. Lenwari, “Optimal design of a 5-mw double-stator single-rotor pmsg for offshore direct drive wind turbines,” in IEEE Transactions on Industry Applications, 2020, vol. 56, no. 1, doi: 10.1109/TIA.2019.2949545.[Cross Ref]
Vijayaprabhu. A and Kumaresan. M (2022), PMSG Wind Turbine Based Current Fed Three Phase Inverter with Model Predictive Control. IJEER 10(2), 282-289. DOI: 10.37391/IJEER.100238.