Research Article |
Performance Enhancement of Boost Converter for Solar Panels System using Genetic Algorithm
Author(s): Yasameen kamil N1*, Omar Khaldoon A2 and Ali Amer Ahmed Alrawi3
Published In : International Journal of Electrical and Electronics Research (IJEER) Volume 11, Issue 2
Publisher : FOREX Publication
Published : 30 May 2023
e-ISSN : 2347-470X
Page(s) : 345-352
Abstract
Solar Panels System (SPS) is a renewable power source with an essential drawback of low output voltage due to the effect of aspects like the intensity of light and ambient temperature. The DC-DC boost converters are significantly used to boost up the SPS voltage under a certain set of conditions. The converter's output voltage and current are unstable, complex, and varied. A three-term controller (proportional, integral, and derivative) is often used because it can control the system’s behavior effectively. The challenge is the selection of the optimum gain parameters of the controller. In this paper, the optimum gain parameters of the controller are selected based on Genetic Algorithm (GA) for the boost converter of SPS. The best operation function of GA based on the tournament, uniform, and constraint dependent is selected by testing and evaluating various genetic algorithm operators, while the objective function based on Integral Time Absolute Error (ITAE) is used to minimize the fitness function. MATLAB code and GA optimization solver are used for simulation results. The simulated results prove the effectiveness of the proposed approach to stabilize and control the boost converter system due to the best specifications of the system. The proposed system enhances the transient response by about (40%) which leads to an increase in the efficiency of the system.
Keywords: Control system
, Three-term controller
, Genetic algorithm
, Solar panel
, Boost converter
.
Yasameen kamil N*, Electrical Engineering Department, University of Anbar, Iraq; Email: yknajm@uoanbar.edu.iq
Omar Khaldoon A, Electrical Engineering Department, University of Anbar, Iraq
Ali Amer Ahmed Alrawi, Electrical Engineering Department, University of Anbar, Iraq
-
[1] M. S. Bin Arif et al., “An improved asymmetrical multi‐level inverter topology with boosted output voltage and reduced components count,” IET Power Electron., vol. 14, no. 12, pp. 2052–2066, 2021. [Cross Ref]
-
[2] K.-J. Lee, B.-G. Park, R.-Y. Kim, and D.-S. Hyun, “Robust predictive current controller based on a disturbance estimator in a three-phase grid-connected inverter,” IEEE Trans. power Electron., vol. 27, no. 1, pp. 276–283, 2011. [Cross Ref]
-
[3] G. Fadhil, I. Abed, and R. Jasim, “Genetic Algorithm Utilization to Fine Tune the Parameters of PID Controller,” Kufa J. Eng., vol. 12, no. 2, pp. 1–12, 2021. [Cross Ref]
-
[4] A. Abdollahi, A. Forruzan Tabbar, and H. Khodadadi, “Optimal Controller Design for Quadrotor by Genetic Algorithm with the Aim of Optimizing the Response and Control Input signals,” Cumhur. Sci. J., vol. 36, no. 3, pp. 135–147, 2015, [Online]. Available: http://dergi.cumhuriyet.edu.tr/cumuscij/article/view/5000118362
-
[5] A. Jayachitra and R. Vinodha, “Genetic Algorithm Based PID Controller Tuning Approach for Continuous Stirred Tank Reactor,” Adv. Artif. Intell., vol. 2014, pp. 1–8, 2014, doi: 10.1155/2014/791230. [Cross Ref]
-
[6] C. Larbes, S. M. A. Cheikh, T. Obeidi, and A. Zerguerras, “Genetic algorithms optimized fuzzy logic control for the maximum power point tracking in photovoltaic system,” Renew. Energy, vol. 34, no. 10, pp. 2093–2100, 2009. [Cross Ref]
-
[7] A. A. Kulaksız and R. Akkaya, “A genetic algorithm optimized ANN-based MPPT algorithm for a stand-alone PV system with induction motor drive,” Sol. Energy, vol. 86, no. 9, pp. 2366–2375, 2012. [Cross Ref]
-
[8] Q. Wang, H. Xi, F. Deng, M. Cheng, and G. Buja, “Design and analysis of genetic algorithm and BP neural network based PID control for boost converter applied in renewable power generations,” IET Renew. Power Gener., vol. 16, no. 7, pp. 1336–1344, 2022, doi: 10.1049/rpg2.12320. [Cross Ref]
-
[9] S. Legg, M. Hutter, and A. Kumar, “Tournament versus fitness uniform selection,” in Proceedings of the 2004 Congress on Evolutionary Computation (IEEE Cat. No. 04TH8753), 2004, vol. 2, pp. 2144–2151. [Cross Ref]
-
[10] R. Faraji and H. Farzanehfard, “Soft-switched non isolated high step-up three-port DC–DC converter for hybrid energy systems,” IEEE Trans. Power Electron., vol. 33, no. 12, pp. 10101–10111, 2018. [Cross Ref]
-
[11] V. K. Kannan and N. Rengarajan, “Photovoltaic system interface with a DC-DC boost converter in D-STATCOM for power quality improvement,” Istanbul Univ. - J. Electr. Electron. Eng., vol. 13, no. 1, pp. 1597–1604, 2013.
-
[12] D. K. Saini and M. K. Kazimierczuk, “Open‐loop transfer functions of buck–boost converter by circuit‐averaging technique,” IET Power Electron., vol. 12, no. 11, pp. 2858–2864, 2019. [Cross Ref]
-
[13] K. M. Sudharshan, “Mathematical Modeling Of Closed Loop Boost Converter,” Turkish J. Comput. Math. Educ., vol. 12, no. 12, pp. 2321–2329, 2021.
-
[14] J. Carr, “An introduction to genetic algorithms,” Sr. Proj., vol. 1, no. 40, p. 7, 2014.
-
[15] R. Abdelrassoul, Y. Ali, and M. S. Zaghloul, “Genetic algorithm optimized PID controller for better performance of PV system,” in 2016 World Symposium on Computer Applications & Research (WSCAR), 2016, pp. 18–22. [Cross Ref]
-
[16] Y. Huang and H. Hu, “Design of fractional order PID controller based on artificial immune algorithm,” Adv. Mater. Res., vol. 268–270, pp. 1061–1066, 2011, doi: 10.4028/www.scientific.net/AMR.268-270.1061. [Cross Ref]
-
[17] L. Chen, G. Chen, R. Wu, A. M. Lopes, J. A. Tenreiro Machado, and H. Niu, “Variable coefficient fractional‐order PID controller and its application to a SEPIC device,” IET Control Theory Appl., vol. 14, no. 6, pp. 900–908, 2020. [Cross Ref]
-
[18] A. Altan and R. Hacıoğlu, “Model predictive control of three-axis gimbal system mounted on UAV for real-time target tracking under external disturbances,” Mech. Syst. Signal Process., vol. 138, p. 106548, 2020. [Cross Ref]
-
[19] M. Y. Amir and V. Abbass, “Modeling of quadrotor helicopter dynamics,” in 2008 International Conference on Smart Manufacturing Application, 2008, pp. 100–105. [Cross Ref]
-
[20] J. Tripathi, K. Sharma, and J. N. Rai, “Speed Control Analysis of Brushless DC Motor Using PI, PID and Fuzzy-PI Controllers,” International Journal of Electrical and Electronics Research, vol. 10, no. 3, pp. 470–474, Sep. 2022, doi: 10.37391/ijeer.100311. [Cross Ref]
-
[21] A. B. Hassanat, V. B. S. Prasath, M. A. Abbadi, S. A. Abu-Qdari, and H. Faris, “An improved Genetic Algorithm with a new initialization mechanism based on Regression techniques,” Inf., vol. 9, no. 7, 2018, doi: 10.3390/info9070167. [Cross Ref]
-
[22] R. Ayop and C. W. Tan, “Design of boost converter based on maximum power point resistance for photovoltaic applications,” Sol. Energy, vol. 160, pp. 322–335, 2018. [Cross Ref]
-
[23] R. Malhotra, N. Singh, and Y. Singh, “Genetic algorithms: Concepts, design for optimization of process controllers,” Computer. Inf. Sci., vol. 4, no. 2, p. 39, 2011. [Cross Ref]
-
[24] M. Abachizadeh, M. R. H. Yazdi, and A. Yousefi-Koma, “Optimal tuning of PID controllers using artificial bee colony algorithm,” in 2010 IEEE/ASME International Conference on Advanced Intelligent Mechatronics, 2010, pp. 379–384. [Cross Ref]
-
[25] V. N. Pudi, G. S. Sarma, S. R. Sura, P. Bolla, and N. S. M. Rao, “Modelling of Electric Vehicle with PID Controller Transfer Function using GA and Model-Reduced Order DRA Algorithm,” IJEER, vol. 9, no. 4, pp. 135–142, 2021. [Cross Ref]
-
[26] M. A. Kallon, G. N. Nyakoe, and C. M. Muriithi, “Development of DSTATCOM Optimal Sizing and Location Technique Based on IA-GA for Power Loss Reduction and Voltage Profile Enhancement in an RDN,” International Journal of Electrical and Electronics Research, vol. 9, no. 4, pp. 96–106, Dec. 2021, doi: 10.37391/ijeer.090402. [Cross Ref]