heet">
FOREX Press I. J. of Electrical & Electronics Research
Support Open Access
  • Home/
  • IJEER-030402

Research Article |

Design Of Monitoring and Fault Diagnosis System in Wind Turbine Based On Can Bus

Author(s): Prathyusha Divi and J.V. Priyadharsini

Published In : International Journal of Electrical and Electronics Research (IJEER)        Volume 3, issue 4

Publisher : FOREX Publication

Published : 30 December 2015

e-ISSN : 2347-470X

Page(s) : 79-81

DOI: https://doi.org/10.37391/IJEER.030402

Abstract

In this paper, design of a monitoring and fault diagnosis system in Wind Turbine based on CAN Bus have been described. The source of electrical energy is fossil fuels and also natural resources. The electrical energy can be produced by using fossil fuels but it is costlier than the natural resources. The natural resources like wind, thermal, Solar and tidal energy are utilized for the production of electrical energy. In present days the mostly wind energy is used as a natural resources which can reduce the emission of carbon dioxide. But the wind turbine costs extremely higher and it is used in under different environment. Thus, it become necessary for wind turbine to be monitored frequently and it should be automated. This paper describes in detail the monitoring and fault diagnosis system using CAN interface for wind turbines. The parameters used for monitoring and CAN bus interface are described in detail.

Keywords: CAN (Controller Area Network), Wind turbine, Fault Diagnosis, monitoring parameters.




Prathyusha Divi*, Department of ECE, Vignan’s Lara institute of technology and science, Vadlamudi, Guntur-522213; Email: prathyushadivi96@gmail.com

J.V. Priyadharsini, Department of ECE, Vignan’s Lara institute of technology and science, Vadlamudi, Guntur-522213; Email: vineelapriyadharsini@gmail.com

    [1] Wang chuhang Network Center of Chanchun Normal University, Remote Monitoring and Diagnosis System for Wind Turbine.
    [2] Wenyi Liu, Baoping Tang, Yonghua Jiang, status and problems of wind turbine structural health monitoring techniques in china, 1ST National conference 2009, vol. 35, no. 7, pp. l4l4-l4l8,July 20l0.
    [3] I. Ribrant and L.B ertling, Survey of failures in Wind power systems with focus on Swedish wind power plants during 1997 - 2005, IEEE transactions on Energy conversion, vol. 22, no, 1, pp. 167-173, March 2007.
    [4].I.Nilsson and L.B ertling, Maintenance management of wind power systems using condition monitoring systems life cycle cost analysis for two case studies, IEEE transactions on Energy Conversion, vol. 22, no. 1, pp. 223-229, march 2007.
    [5] Fang Li, Lifang Wang, Chenglin Liao, CAN (Controller Area Network) B us Communication system Based on Matlab/Sim ul ink. Available: http://www.ieeexplore.ieee.org.
    [6] Van. R and Geo .R.X, 2010, "Harmonic Wavelet-Based Data Filtering for Enhanced Machine Defect Identification.
    [7] YLu, J Tang, April 2012, Wind Turbine Gearbox Fault Detection using Multiple Sensors with Features Level Data Fusion.
    [8] Analytical techniques for performance monitoring of modern wind turbines, 20 12EWEA, Copenhagen.

Prathyusha Divi and J.V. Priyadharsini (2015), Design Of Monitoring and Fault Diagnosis System in Wind Turbine Based On Can Bus. IJEER 3(4), 79-81. DOI: 10.37391/IJEER.030402.