[Cross Ref] Comparative Study of NCM and NCA Electrode Material for Capacity-Fade Using 1-D Modeling
FOREX Press I. J. of Electrical & Electronics Research
Support Open Access
  • Home/
  • IJEER-100308

Research Article |

Comparative Study of NCM and NCA Electrode Material for Capacity-Fade Using 1-D Modeling

Author(s) : Ebani Gupta1, Vikas Verma2, Gaurav Khulway3 Amrish K. Panwar4

Published In : International Journal of Electrical and Electronics Research (IJEER)        Volume 10, Issue 3, Special Issue on Recent Advancements in the Electrical & Electronics Engineering

Publisher : FOREX Publication

Published : 10 August 2022

e-ISSN : 2347-470X

Page(s) : 454-459

DOI: https://doi.org/10.37391/IJEER.100308

Abstract

Today, Lithium-ion (Li-ion) batteries are one of the most emerging power sources for almost all modern consumer electronic products. LiNi0.8Co0.15Al0.05O2 (NCA) and LiNi0.3Co0.3Mn0.3O2 (NCM) are projected to be utilized in lithium-ion power batteries as two typical layered nickel-rich ternary cathode materials. Moreover, there is still a need for systematic study from an industrial aspect as to the advantages and drawbacks of these two nickel-rich materials. Hence, a comparative study of NCM and NCA electrode material for capacity-fade has been explored using a 1-D simulated model constructed in the multi-physics software. The capacity of a battery depends on the cell potential, discharge rate, state of charge (SoC), and state of health (SoH). Therefore, the comparison of these parameters and the cycle number of a battery is extremely important. During this comparative study of NCM and NCA electrode material, the capacity fade based on discharge rate, SoC, and SoH over cycle number of a battery has been reported.

Keywords: Lithium-ion battery, NCM, NCA, Capacity-fade, Battery Modelling




Ebani Gupta, Department of Applied Physics, Delhi Technological University, Delhi, India; Email: ebani.ecelldtu@gmail.com

Vikas Verma, Department of Applied Physics, Delhi Technological University, Delhi, India; Email: technovikas06@gmail.com

Gaurav Khulway, Department of Applied Physics, Delhi Technological University, Delhi, India; Email: gauravkhulway16@gmail.com

Amrish K. Panwar, Department of Applied Physics, Delhi Technological University, Delhi, India; Email: amrish.phy@dtu.ac.in

    [1] Snigdha Sharma; Amrish K Panwar; Madan Mohan Tripathi. Investigation of Electrochemical, Thermal and Electrical Performance of 3D Lithium-Ion Battery Module in a High - Temperature Environment. Int. Journal of Renewable Energy Development 9 (2) 2020: 151-157[Cross Ref]
    [2] Naoki Nitta; Feixiang Wu; Jung Tae Lee; Gleb Yushin1. Li-ion battery materials: present and future. Materials Today; Volume 18; Number 5; June 2015.[Cross Ref]
    [3] Snigdha Sharma; Amrish K Panwar; Madan Mohan Tripathi. Thermal-Electrochemical Modeling and Analysis of Different Cathode-Anode Pairs for Lithium-ion Battery. Advances in Electrical and Computer Engineering. Volume 21, Number 3, 2021[Cross Ref]
    [4] Capron, O.; Gopalakrishnan, R.; Jaguemont, J.; Van Den Bossche, P.; Omar, N.; Van Mierlo, J. On the Ageing of High Energy Lithium-Ion Batteries—Comprehensive Electrochemical Diffusivity Studies of Harvested Nickel Manganese Cobalt Electrodes. Materials 2018, 11, 176.[Cross Ref]
    [5] IBEF. Automobile Industry in India. https://www. ibef.org/industry/india- automobiles.aspx. [Online; accessed Nov-2021]. 2021.[5] Li, Z.; Chernova, N.A.; Roppolo, M.; Upreti, S.; Petersburg, C.; Alamgir, F.M.; Whittingham, M.S. Comparative Study of the Capacity and Rate Capability of LiNi y Mn y Co1–2y O2 (y = 0.5, 0.45, 0.4, 0.33). J. Electrochem. Soc. 2011, 158, A516. [Cross Ref]
    [6] Forte, F.; Pietrantonio, M.; Pucciarmati, S.; Puzone, M.; Fontana, D. Lithium Iron Phosphate Batteries Recycling: An Assessment of Current Status. Crit. Rev. Environ. Sci. Technol. 2020, 1–28.[Cross Ref]
    [7] Yang, H.; Savory, C.N.; Morgan, B.J.; Scanlon, D.O.; Skelton, J.M.; Walsh, A. Chemical Trends in the Lattice Thermal Conductivity of Li(Ni, Mn, Co)O2 (NCM) Battery Cathodes. Chem. Mater. 2020, 32, 7542–7550.[Cross Ref]
    [8] He, H.; Xiong, R.; Guo, H.; Li, S. Comparison Study on the Battery Models Used for the Energy Management of Batteries in Electric Vehicles. Energy Convers. Manag. 2012, 64, 113–121[Cross Ref]
    [9] Gurpreet Singh; Anjan Sil; Sudipto Ghosh ; Amrish Panwar. Effect of citric acid content on synthesis of LiNi1/3Mn1/3Co1/3O2 and its electrochemical characteristics. Ceramics International 36 (2010) 1831–1836.[Cross Ref]
    [10] Li, K.; Zhang, J.; Chen, M.; Yang, Z.; Niu, Q. Advances in Green Energy Systems and Smart Grid; Springer: Singapore, 2018; ISBN 9789811323812.[Cross Ref]
    [11] Miao, Y.; Hynan, P.; von Jouanne, A.; Yokochi, A. Current Li-Ion Battery Technologies in Electric Vehicles and Opportunities for Advancements. Energies 2019, 12, 1074.[Cross Ref]
    [12] Snigdha Sharma; Amrish K Panwar; Madan Mohan Tripathi. Enhanced Electrical and Mechanical Characteristics Monitored by Various Software for Lithium-Ion Battery Tests. Lecture Notes in Electrical Engineering , LNEE, volume 664.[Cross Ref]
    [13] Simon Malifarge; Bruno Delobel; Charles Delacourt. Experimental and Modeling Analysis of Graphite Electrodes with Various Thicknesses and Porosities for High-Energy-Density Li-Ion Batteries. Journal of The Electrochemical Society, Volume 165, Number 7[Cross Ref]
    [14] Willem Van Zyl. Analysis of Graphite for Lithium Ion Batteries. 07.07.2021
    [15] S.S. Zhagn; T.R.Jow; K.Amine; G.L. Henriksen. LiPF6-EC-EMC electrolyte for Li-ion Battery. ELSAVIER, Journal of Power Sources 107 (2002) 18 - 23[Cross Ref]
    [16] Türev Sarıkurt, Murat Ceylan; Abdulkadir Balıkçı. An Analytical Battery State of Health Estimation Method. Industrial Electronics (ISIE), 2014 IEEE 23rd International Symposium[Cross Ref]
    [17] Du, Zhijia ORCiD logo; Wood, David L.; Daniel, Claus; Kalnaus, Sergiy; Li, Jianlin. Understanding limiting factors in thick electrode performance as applied to high energy density Li-ion batteries.Springer Science+Business Media Dordrecht 2017. J Appl Electrochem (2017) 47:405–415.[Cross Ref]
    [18] Denny Schmidta; Marc Kamlahb; Volker Knoblauchc. Highly densified NCM-cathodes for high energy Li-ion batteries: Microstructural evolution during densification and its influence on the performance of the electrodes. Journal of Energy Storage 17 (2018) 213-233[Cross Ref]
    [19] Ruhul Amin; Dorthe B. Ravnsbaek; Yet Ming Chian. Characterization of transport properties of LiNi0.8Co0.15Al0.05O2 (NCA). Abstract #260; 224th ECS Meeting; 2013 The Electrochemical Society. [Cross Ref]
    [20] Duygu Karabelli; Kai Peter Birke; Max Weeber. A Performance and Cost Overview of Selected Solid-State Electrolytes: Race between Polymer Electrolytes and Inorganic Sulfide Electrolytes. MDPI Review; 5 March 2021.[Cross Ref]
    [21] Sufia Banu and Shweta Gupta (2022), Design and Leakage Power Optimization of 6T Static Random Access Memory Cell Using Cadence Virtuoso. IJEER 10(2), 341-346. DOI: 10.37391/IJEER.100246.[Cross Ref]
    [22] Pushkar Praveen and Rakesh Kumar Singh (2022), Performance Analysis of 9T SRAM using 180nm, 90nm, 65nm, 32nm, 14nm CMOS Technologies. IJEER 10(2), 381-386. DOI: 10.37391/IJEER.100253.[Cross Ref]
    [23] Sachin B. Shahapure, Vandana A. Kulkarni (Deodhar) and Sanjay M. Shinde (2022), A Technology Review of Energy Storage Systems, Battery Charging Methods and Market Analysis of EV Based on Electric Drives. IJEER 10(1), 23-35. DOI: 10.37391/IJEER.100104.[Cross Ref]

Ebani Gupta, Vikas Verma, Gaurav Khulway and Amrish K. Panwar (2022), Comparative Study of NCM and NCA Electrode Material for Capacity-Fade Using 1-D Modeling. IJEER 10(3), 454-459. DOI: 10.37391/IJEER.100308.